Harman XXV Owners Manual Care And Operation

Harman® •  Owners anualR2 • 200 - • 0811 3 3 -9 0 -0 0 6 8 4 c
Igniter Switch to " AUTO" (up position)
ake sure the unit is plugged into a properly grounded, 120
AC, 0 Hz electrical source. The power light should be the
only light lit.
Note: Be sure there is no fuel or other combustibles in
the ash pan prior to lighting.
1. Turn ode Selector to O.
2. ill hopper with pellets.
. Clean burn pot with scraper, if necessary.
. If starting after an empty hopper, turn eed Aduster to
TEST (for one 0 second cycle).
2
This will ow pellets
into the auger tube and also allow you to check the motors
for operation.
NOTE: The auger motor will not operate with the view
door open.
5. Turn eed Aduster to #.
4
. lip the Igniter Switch up into the AUTO position.
7. Turn the Temperature ial to the desired room temperature.
8. Turn ode Selector to Room Temperature or Stove
Temperature.
. ill hopper with pellets and remove ashes as required.
eep the hopper lid and rebox doors closed while in
operation. aintain door seals in good condition. ailure
to do so will affect operation of the appliance and may
permit escape of smoke or gases into the living space.
1. Finesaresmallpiecesofbrokenpellets(sawdust).Fines
donotoweasilyandoftenbuilduponthehopperfunnel
bottomangles.Thesenescanbepushedintothefeeder
openingandthenllthehopperwithpellets.Asthesystem
works,theywillbeburned.
2. The "TEST" cycle will operate the feed motor for exactly
oneminute.Turningto"TEST"againandagainmayload
toomuchfuelintotheburnpotcausingexcessivesmoke
on start-up.
3. Thereboxlowpressureswitchwillnotallowtheauger
motorortheigniterelementtooperateiftheviewdooris
open.
4. AdjustFeedRate.Ifthisisyourrstreoryouaretrying
differentpellets,setthefeedadjusterto#4,Figure4.6
Thisisaconservativenumberandwillprobablyneedto
beincreased.Afteryouknowafeedratesettingthatworks
well,usethatsetting.Remember,ifyourfeedrateistoo
highyoumaywastefuel.
5. Thisisusuallyaweeklymaintenanceprocedure.Cleaning
the burn pot with the scraper with a small amount of new
fuel in the bottom is not a problem. First, scrape the ashes
off the front of the burn pot into the ash pan. Then scrape
the holed surface downward into the burn pot. When the
stovefeeds,thesescrapingswillbepushedoutbythe
feeder.
6. Theashpancanholdtheashesfromapproximately1ton
of premium fuel. This means the ashes will only need to
be emptied a few times a year.
7. Settingthefeedadjuster#formaximumburn:Withthe
unitburningin"AUTO",turnto"StoveMode"andputthe
fanon"H".SettheTemperatureDialto#7.Allowtheunit
toburnforabout30minutesandcheckashonfrontof
burnpot.Figure4.7.Iftheashlineislargerthan1",turn
thefeedadjusterfrom#4to#5.Allowanother30minutes
ofburn timeand check again.If, at#6 setting,a1" or
lessashbedisnotobtainable,itisnotaproblem.The1"
ashbedisonlyatmaximumburnrateandduringnormal
operation,theashbedwillbelarger.
W AR NING
NEV ER USE G ASOLINE, G ASOLINE-TY PE LANTER N
F UEL, K ER OSENE, CHAR COAL LIG HTER F LUID, OR
SIMILAR LIQ UIDS TO STAR T OR ' F R ESHEN UP' A F IR E
IN THIS HEATER . K EEP ALL SUCH LIQ UIDS W ELL
AW AY F R OM THE HEATER , W HILE IN USE.
W AR NING
BUR NING G AR BAG E, USE OF IMPR OPER F UELS,
F IR E STAR TER S OR ALTER ING THE STOV E F OR
HIG HER HEAT OUTPUT MAY CAUSE DAMAG E TO THE
STOV E AND COULD R ESULT IN A HOUSE F IR E. USE
ONLY APPR OV ED F UELS AND F OLLOW ONLY THESE
OPER ATION G UIDELINES.
F igure 4 .6
SeeNote7
1"
F igure 4 .7
E. Automatic Ignition

Harman XXV Specifications

General

Brand	Harman
Model	XXV
Category	Pellet stove
Language	English