6
SECTION 3. INSTALLATION
Outdoor/Indoor vents:
The H-Series heaters may be installed
outdoors when equipped with the integral vent
(Figure 5) or the optional high wind HWS vent
(Figure 6). For indoor installations, a DHI vent
(Figure 7) must be used. All models except the
H210 may be installed indoor using a DHI vent.
The H210 cannot be installed indoor.
! NOTE: For Canadian indoor installations,
these heaters can only be installed in an enclo-
sure that is not normally occupied and does not
directly communicate with occupied areas; i.e.
outdoor shelter.
Check to be sure that the vent supplied with
the heater is the correct one for the installation
location.
Outdoor heater-high
wind conditions:
In areas where high winds are a daily occur-
rence, or where severe downdrafts are present
due to surrounding structures, it may be neces-
sary to install the HWS high wind vent (Figure
6). Installation instructions are provided in the
carton with the HWS vent.
Figure 5: Integral Vent
Figure 6: High Wind Vent (HWS) Figure 7: Indoor Drafthood (DHI)
To Next Page
Loading...
Need help?
General
