Non-use or vacation
If you are intending to go on vacation or don’t intend to use your washer for an extended
period of time, you should:
• Turn off the water taps, this helps avoid accidental flooding (due to a water pressure
surge) while you are away.
• Switch off the power outlet and remove the plug from the power outlet.
Remove the plug
by grasping the plug – do not pull on the cord.
Cleaning the water inlet filter
After a period of time, the water inlet mesh filter (in the Skirtlike nut) may become blocked
with lint or sediment, and should be cleaned as per the following steps:
(1)
Switch on the power,
followed by turning off the
water supply.
(2) Press the Start/Pause
buttons and allow the
washer operates for 5
seconds so that all the
water, through the hose,
flows into the tub. Push
the Power button to turn
the washer off, pull the
plug from the power
outlet by grasping it; do
not pull on the power
cord.
(3) Disconnect the water inlet
hoses from the rear of the
machine.
(4) Pull the water inlet filter with a
pair of pliers and clean the
filters with a brush.
(5) After cleaning, insert
the filter into the inlet.
Reinstall the inlet
hoses tightly and
securely.
Cleaning the lint filter
After every wash, the lint filter, located on the side of the tub should be cleaned as per the
following steps:
Remove the lint filter assembly by depressing the thumb latch and remove from the tub.
Fold out the rear section of the filter assembly, remove any lint, etc., and,
Wash with warm soapy water until the filter fabric and holes are free and clean.
Reinstall the filter assembly into the tub.
14
To Next Page
Loading...
Need help?
General
