or portable outlet device, is safe to use, capable of handling the electrical load of the washing
machine (refer to the identification plate) and has been checked and tested by your electrical
supplier or qualified technician.
Always position the extension cord or portable outlet device so it is not subject to splashing or
ingress of moisture.
To avoid becoming entangled in the cord, never lay it through or along a walkway or
thoroughfare.
We recommend, a permanent earthed power outlet be fitted in close vicinity of the washing
machine. Electrical installations must only be undertaken by fully qualified and licensed
persons.
Installation of the base cover
• Tilt the washing machine forward to angle of 45° in the
direction of the arrows shown in the illustration and side the
base cover (from the back of the machine) under the
moulded clips (sides and front) in the base of the machine
• Secure the back face with a self tapping screw.
USING YOUR WASHER
Preparation
1. Make sure the water inlet hoses are connected to the Hot and Cold taps and the washer.
2. Plug the Power Cord into an Earthed Power Outlet and turn ON.
Important: Always operate the Product from a power source of the same Voltage,
Frequency and rating as indicated on the product identification plate.
3. Load suitable wash load into machine. To obtain the best washing results, you must load
and operate your washer as recommended.
4. Make sure the drain hose is firmly attached to the outlet of the machine and attached to a
drainage outlet, or hung over/into a sink, trough etc.
5. Fill detergent draw, fabric softener dispenser and bleach dispenser (as required) with
recommended by supplier, correct amount of product.
6
To Next Page
Loading...
Need help?
General
