EasyManuals Logo
Home>Hikmicro>Thermal cameras>M10

Hikmicro M10 User Manual

Hikmicro M10
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Handheld Thermography Camera User Manual
vii
maintenance.
A few device components (e.g., electrolytic capacitor) require regular replacement. The average
lifespan varies, so periodic checking is recommended. Contact your dealer for details.
Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the device may be impaired.
Please notice that the current limit of USB 3.0 PowerShare port may vary with the PC brand,
which is likely to result in incompatibility issue. Therefore, it’s advised to use regular USB 3.0 or
USB 2.0 port if the USB device fails to be recognized by PC via USB 3.0 PowerShare port.
We recommend you send the device back for calibration once a year, and please contact the
local dealer for the information on maintenance points.
Using Environment
DO NOT expose the device to extremely hot, cold, dusty, corrosive, saline-alkali, or damp
environments. Make sure the running environment meets the requirement of the device. The
operating temperature shall be -10°C to 50°C (1F to 122°F), and the operating humidity shall
be 90% or less.
This device can only be safely used in the region below 2000 meters above the sea level.
Place the device in a dry and well-ventilated environment.
DO NOT expose the device to high electromagnetic radiation or dusty environments.
DO NOT aim the lens at the sun or any other bright light.
When any laser equipment is in use, make sure that the device lens is not exposed to the laser
beam, or it may burn out.
The device is suitable for indoor conditions.
The pollution degree is 2.
Overvoltage category: 0 for Handheld Thermography Camera.
Overvoltage category: II for power adapter.
Technical Support
The https://www.hikmicrotech.com portal will help you as a HIKMICRO customer to get the most
out of your HIKMICRO products. The portal gives you access to our support team, software and
documentation, service contacts, etc.
Emergency
If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the
power cable, and contact the service center.
Laser Light Supplement Warning
Warning: The laser radiation emitted from the device can cause eye injuries, burning of skin or
inflammable substances. Prevent eyes from direct laser. Before enabling the Light Supplement

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hikmicro M10 and is the answer not in the manual?

Hikmicro M10 Specifications

General IconGeneral
USB portYes
USB connector typeUSB Type-C
Micro HDMI ports quantity1
Sensor type-
Fixed focal length25 mm
Sensor resolution (thermal module)640 x 480 pixels
Input voltage100 - 240 V
Charging sourceUSB
Cables includedHDMI, USB
Number of batteries included2 pc(s)
Battery capacity- mAh
Battery life (max)4 h
Battery recharge time2.5 h
SafetyIEC 61010-1
Display typeLCD
CertificationAustralian RCM
Product colorBlack
Tripod thread1/4-20 \
Display diagonal5 \
Display resolution1280 x 720 pixels
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)-20 - 50 °C
Operating relative humidity (H-H)0 - 95 %
International Protection (IP) codeIP54
Accuracy2 °C
Laser typeClass II
Laser wave power1 mW
Laser wavelength635 nm
Total megapixels8 MP
Camera pixel size17 µm
Measurement modesCenter spot, Cold spot, Hot spot, Off
Standard palettesBlack Hot, Fusion, Rain, Rainbow, Red Hot, White Hot
Maximum resolution3264 x 2448 pixels
Infrared spectral band8 - 14 µm
Vertical field of view18.7 °
Horizontal field of view24.8 °
IFOV (spatial resolution)0.68 mRad
Thermal sensitivity (NETD)30 mK
Sensor type (thermal module)Vanadium Oxide Uncooled Focal Plane Arrays
Temperature measurement range-20 - 650 °C
Wi-Fi bandSingle-band (2.4 GHz)
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth version4.2
Languages supportMulti
Management softwareHIKMICRO Analyzer, HIKMICRO Viewer App, UVC Alarm Clien
Number of languages21
Video memory capacity64 h
Compatible memory cardsSD
Image formats supportedJPEG
Video formats supportedMP4
Maximum memory card size128 GB
Memory capacity (images)60000
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth118.3 mm
Width284.7 mm
Height127.1 mm
Weight653 g

Related product manuals