User Manual of Network Camera
82
Figure 6-51 Audio Exception Configuration
6.6.8 Configuring Line Crossing Detection
This function can be used for detecting people, vehicles and objects crossing a
pre-defined area. The line crossing direction can be set as bidirectional, from left to
right or from right to left. And a series of linkage method will be triggered if any object
is detected.
Steps:
1. Check the Enable Line Crossing Detection checkbox.
2. Click the Draw Area, and a crossing plane will show on the image.
3. Click on the line, and you will see two red squares on each end, drag one of
the red squares to define the arming area.
To Next Page
Loading...
Need help?
General
