User Manual of DS-7200/7300/8100-SH Series DVR
189
• Operator: The Operator user level has permission of Local Log Search in Local Configuration,
Remote Log Search and Two-way Audio in Remote Configuration and all operating permission in
Camera Configuration.
• Guest: The Guest user has permission of Local Log Search in Local Configuration, Remote Log
Search in Remote Configuration and only has the local/remote playback in the Camera Configuration.
User’s MAC Address: The MAC address of the remote PC which logs onto the device. If it is configured
and enabled, it only allows the remote user with this MAC address to access the device.
4. Click the OK button to save the settings and go back to the User Management interface. The added new
user will be displayed on the list, as shown in Figure 13.6.
Figure 13.7 Added User Listed in User Management Interface
5. Select the user from the list and then click the button to enter the Permission settings interface.
Figure 13.8 User Permission Settings Interface
Note: Local Camera Management is supported by HDVR series.
6. Set the operating permission of Local Configuration, Remote Configuration and Camera Configuration for
the user.
Local Configuration
• Local Log Search: Searching and viewing logs and system information of device.
• Local Parameters Settings: Configuring parameters, restoring factory default parameters and
importing/exporting configuration files.
• Local Camera Management: Enabling and disabling analog camera (s). Adding, deleting and
editing of network camera (s). This function is supported by HDVR series.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
