User Manual of Network Camera
72
3. Set the Alarm Actions for Motion Detection.
Check the checkbox to select the linkage method. Notify surveillance center,
send email, upload to FTP, trigger channel and trigger alarm output are selectable.
You can specify the linkage method when an event occurs.
Figure 6-42 Linkage Method
Audible Warning
Trigger the audible warning locally. And it only supported by the device have
the audio output.
Notify Surveillance Center
Send an exception or alarm signal to remote management software when an
event occurs.
Send Email
Send an email with alarm information to a user or users when an event occurs.
Note: To send the Email when an event occurs, you need to refer to Section
6.6.6 to set the related parameters.
Upload to FTP
Capture the image when an alarm is triggered and upload the picture to a FTP
server.
Note: Set the FTP address and the remote FTP server first. Refer to Section
6.3.10 for detailed information.
Trigger Channel
The video will be recorded when the motion is detected. You have to set the
recording schedule to realize this function. Please refer to Section 7.2 for
To Next Page
Loading...
Need help?
General
