Network Camera User Manual
86
can configure ONVIF user in this interface. Refer to ONVIF standard for detailed
configuration rules.
CGI
Check the Enable Hikvision_CGI checkbox and then select the authentication
from the drop-down list.
Note: Digest is the recommended authentication method.
ONVIF
Steps:
1. Check the Enable ONVIF checkbox to enable the function.
2. Add ONVIF users. Up to 32 users are allowed.
Set the user name and password, and confirm the password. You can set the
user as media user, operator, and administrator.
Note: ONVIF user account is different from the camera user account. You
have set ONVIF user account independently.
3. Save the settings.
Note: User settings of ONVIF are cleared when you restore the camera.
Bandwidth Adaptation
When you enable the function, live view fluency is taken as the priority of camera
performance. The camera adjusts video-related parameters automatically, and the
pre-set video-related configuration is invalid. A reboot is required for the function to
take effect.
Note: Bandwidth adaptation is only available for certain camera models.
Network Service
You can control the ON/OFF status of certain protocol that the camera supports.
Note:
• Keep unused function OFF for security concern.
• Supported function varies according to camera models.
To Next Page
Loading...
Need help?
General
