User Manual of Network Camera
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 5-7 TCP/IP Settings
2. Configure the NIC settings, including the NIC Type, IPv4 Address, IPv4 Subnet
Mask, IPv4 Default Gateway, MTU settings and Multicast Address.
Notes:
The valid value range of MTU is 500 ~ 1500.
The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address. Before utilizing this function, you have to enable the
Multicast function of your router.
3. If the DHCP server is available, you can check to automatically obtain an
IP address and other network settings from that server.
4. If the DNS server settings are required for some applications (e.g., sending email),
you should properly configure the Preferred DNS Server.
Figure 5-8 DNS Server Settings
5. Click to save the above settings.
Note: it will ask for a reboot for the settings to take effect.
5.3.2 Configuring Port Settings
Purpose:
You can set the port No. of the camera, e.g. HTTP port, RTSP port and HTTPS port.
Steps:
1. Enter the Port Settings interface:
Configuration > Basic Configuration > Network > Port
Or Configuration > Advanced Configuration > Network > Port
To Next Page
Loading...
Need help?
General
