panel is turned into green, it means you can use IR controller to operate this DVR.
Stop using IR controller
When IR controller status is on, press【DEV】key again, the “STATUS” lamp will
be turned off. The IR controller can not control this DVR.
Switch the DVR off
When IR controller status is on, press【POWER】key for several seconds, the
DVR will be powered off.
When IR controller can not work normally
z Check batteries poles.
z Check the remaining charge in the batteries.
z Check IR controller sensor is mask.
z Please change another IR controller to try again. It the problem is still existed,
please contact administrator.
11
To Next Page
Loading...
Need help?
General