5.8 View Tampering Alarm
If you enable this function, when someone blocks the camera spitefully, DVR will make
warning alarm.
Step 1: Enter into “Camera” menu:
Step 2: Select camera: Please use【Ç】【È】keys to select one camera.
Step 3: Select sensitivity: move active frame to sensitivity item right beside the “View
tampering” item. Press 【edit】key, then you can use【↑】【↓】keys to select the sensitivity for
“View Tampering” item. The sensitivity options are: Low, Normal and High. Select one of them
will active “Area Setup” and “Policy” configuration.
Step 4: View tampering area setup Move “Active Frame” to “Area” button, press
【ENTER】key to enter into area setup interface. The setup methods are same as that of mask area
setup. After setup the area, press【ENTER】key to return “Advanced settings” menu. You can press
【ESC】key to abort.
Only one view tampering area can be setup, and the size of the area can be full screen.
Step 5: View tampering alarm setup In “Advanced settings” menu, move “Active Frame”
to “Policy” button, press【ENTER】k Tampering Handle” menu: Shown as
fig 5
ey to enter into “View
.15
Fig 5.15 View tampering handle setup
50
To Next Page
Loading...
Need help?
General