HIKVISION DS-HD1 Installation Guide

9. Restore the electricity at the breaker.
Doorbell is powered on when its indicator flashes blue quickly. If not, make sure your electricity is off and check
the wiring. If yes, proceed to doorbell setup.
For the first time use, please power on the doorbell and wait for 3 hours before using it, or the chime in your
home may not work.
Doorbell Setup
1. Add to the Hik-Connect app (v3.12.0+).
Connect your mobile phone to Wi-Fi.
Download and install the Hik-Connect app by scanning the QR Code below.
Open the Hik-Connect app and register a Hik-Connect user account following the start-up wizard, and log
in.
On the Home screen, tap “+” on the upper-right corner to go to the Scan QR Code page.
Scan the QR code on the device or the cover of this manual when the indicator flashes blue.
Follow the app wizard to finish Wi-Fi configuration.
If you want to change your doorbell’s Wi-Fi, press and hold the reset button for 5s and repeat this
step.
2. Replace the faceplate and insert two security screws into the bottom of the doorbell to secure the faceplate.

HIKVISION DS-HD1 Specifications

General

Brand	HIKVISION
Model	DS-HD1
Category	Accessories
Language	English