Video Intercom Door Station·User Manual
18
4. Enter the user name and password, and click OK to save the settings.
Only the devices that are successfully logged in will be added to the device list for
configuration.
7.2.2 Adding Device by IP Address
Click and the adding devices dialog box pops up.
Task 1: Add by IP Address
Purpose:
You can add the device by inputting IP address.
Steps:
1. Select IP Address in the Adding Mode drop-down list, input the IP address in the IP
Address field, and set the port No., user name and password of the device.
Figure 7-5 Adding by IP Address
2. Click OK to add the device to the device list.
Task 2: Add by IP Segment
Purpose:
You can simultaneously add many the devices whose IP addresses are among the IP
segment.
Steps:
1. Select IP Segment in the Adding Mode drop-down list, enter the Start IP Address
and End IP Address, and set the port No., user name and password.
You cannot add the device(s) to the device list if the user name, password or port No. is
incorrect.
To Next Page
Loading...
Need help?
General
