HIKVISION DS-PHA48-EP User Manual

22
5. Edit the zone name.
6. Check linked areas.
Note
 Only enabled areas will be listed.
 The newly added peripheral is linked to area 1 by default.
7. Select a zone type.
Instant Zone
This Zone type will immediately trigger an alarm event when armed.
Delay Zone
-Exit Delay: Exit Delay provides you time to leave through the zone without alarm.
Arm with faults is enabled: You should confirm faults first, and then the zone is in arming
process. If the delay zone is triggered within the exit delay time but it restores before the
time ends, the alarm will not be triggered and the zone will be armed.
Arm with faults is disabled: Immediately armed. If the delay zone is triggered within the exit
delay time but it restores before the time ends, the alarm will not be triggered.
-Entry Delay: Entry Delay provides you time to enter the zone to disarm the system without
alarm.
After triggering, if the zone is not disarmed or silenced before the entry delay time ends, the
zone will alarm.

HIKVISION DS-PHA48-EP Specifications

General

2G standards	GSM
Number of alarm zones	48
Alert notification type	SMS
Connectivity technology	Wired & Wireless
Mobile network generation	4G
Smartphone remote support	Yes
Number of simultaneous users	48 user(s)
Control type	-
Mounting type	Wall
Product color	White
Housing material	Plastic
Number of door/window sensors	- pc(s)
Battery life	36 h
Input voltage	100 - 240 V
Battery voltage	13.5 V
Battery capacity	7000 mAh

Weight and Dimensions

Alarm control panel weight	996.5 g
Alarm control panel dimensions (W x D x H)	261 x 86.4 x 261 mm