QSG EKI-K41B44W Kit 110520NA 11
Hold RESET about 10s when the camera is powering on or rebooting to restore the
default settings, including the user name, password, IP address, port no., etc.
2 NVR Installation
2.1 Precautions
During installation of the NVR:
●
Use brackets for rack mounting.
●
Ensure ample room for audio and video cables.
●
When routing cables, ensure that the bend radius of the cables is no less than five times than its
diameter.
●
Connect the alarm cable.
●
Allow at least 2 cm (~0.75-inch) of space between racks mounted devices.
●
Ensure the NVR is grounded.
●
Environmental temperature should be within the range of -10° to +55° C, +14° to +131° F.
●
Environmental humidity should be within the range of 10% to 90%.
2.2 Hard Disk Drive Installation
Before You Start
●
If the NVR has been installed with hard disks, skip this section.
●
Disconnect the power from the NVR before installing a hard disk drive (HDD). Use only a factory
recommended HDD for this installation.
●
Tools Required: Screwdriver.
1.
Remove the cover from the device by unfastening the screws on the panels.
Figure 5, Remove Cover
2.
Connect the data cable and power cable.
a) Connect one end of data cable to the device motherboard.
b) Connect the other end of data cable to HDD.
To Next Page
Loading...
Need help?
General
