QSG EKI-K41B44W Kit 110520NA 20
1.
Right click the screen and select Menu > Camera.
2.
Click the Enable Repeater button to enable the NVR’s repeater function.
Make sure the distance between each camera and the NVR is no more than 49 ft (15
m), the NVR’s maximum Wi-Fi range. Any camera beyond this range can use an in-
range camera’s repeater function to communicate with the NVR. The camera’s
repeater function can extend the range to another camera an additional 49 ft (15 m).
The Wi-Fi range will vary by local conditions (e.g., number of walls, materials,
electrical interference, etc.).
3.
Install the camera that is to be used as a repeater at the desired position within the NVR’s Wi-Fi range,
and power it on.
4.
Click the in-range repeater camera’s Repeater switch so that it toggles to the right (it will display a
green background) to enable its repeater function.
5.
Install the camera at the desired position beyond the NVR’s normal range and power it on. It will then
connect to the NVR through the repeater camera.
NOTE: Only one camera can use any one camera’s repeater function.
The repeater function cannot be daisy-chained.
Figure 19, Activating Repeater Function on Camera Management Screen
To disable a camera’s repeater function, click the Repeater switch so that it
toggles to the left (the background will no longer be green).
To disable the NVR’s repeater function, click the Disable Repeater button .
To Next Page
Loading...
Need help?
General
