Network Traffic Camera User Manual
28
8.6 Configure HTTPS
Purpose:
HTTPS provides authentication of the web site and associated web server that one is
communicating with, which protects against Man-in-the-middle attacks. Perform the
following steps to set the port number of https.
Example
If you set the port number as 443 and the IP address is 192.168.1.64, you may access
the device by inputting https://192.168.1.64:443 via the web browser.
Note:
The HTTPS port can be only configured through the web browser.
1. Go to Configuration > Device Configuration > System Configuration >
HTTPS.
Figure 8-6 HTTPS Configuration
2. Create and install the certificate.
OPTION 1: Create private certificate.
1) Click Create private certificate.
2) Click Create and the following message box pops up as below.
To Next Page
Loading...
Need help?
General
