HIKVISION NETWORK CAMERA User Manual

User Manual of Network Camera
156
Figure 12-13 Restore Default Settings
Note: After restoring the default settings, the IP address is also restored to
the default IP address, please be careful for this action.
12.7.3 Exporting / Importing Configuration File
Purpose:
Configuration file is used for the batch configuration of the camera, which can
simplify the configuration steps when there are a lot of cameras needing configuring.
Steps:
1. Enter the Maintenance interface: Configuration > Basic Configuration> System >
Maintenance, or Configuration>Advanced Configuration> System > Maintenance
2. Click Export to export the current configuration file, and save it to the certain
place.
3. Click Browse to select the saved configuration file and then click Import to start
importing configuration file.
Note: You need to reboot the camera after importing configuration file.
4. Click Export and set the saving path to save the configuration file in local
storage.
Figure 12-14 Import/Export Configuration File

HIKVISION NETWORK CAMERA Specifications

General

Operating Temperature	-30 °C to 60 °C (-22 °F to 140 °F)
Lens	Fixed or varifocal (depending on model)
Compression	H.265+, H.265, H.264+, H.264
Audio	Built-in microphone and/or audio input/output (depending on model)
Network	Ethernet (RJ-45)
Power Supply	PoE or DC 12V (depending on model)
Weatherproof	IP66 or IP67 (depending on model)
Image Sensor	CMOS (depending on model)
Smart Features	Motion detection, line crossing detection, intrusion detection
Storage	MicroSD card slot (up to 256GB), NAS
Network Interface	10/100 Mbps Ethernet