Figure 2. 2 Remove the Clip Plate
4. Fix the mounting base to the ceiling with supplied
screws.
Note:
In the supplied screw package, both self-tapping
screws and expansion blots are contained.
If the wall is cement, expansion blots are required
to fix the camera. If the wall is wooden,
self-tapping screws are required.
5. Route the cables through the cable hole and
connect the corresponding cables, such as power
cable and video cable.
6. Install the main body onto the mounting base and
insert the clip plate.
7. Tighten the screw with the wrench.
Figure 2. 3 Install the Turret Camera
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
0° to 360°
0° to 360°
0° to 75°
Figure 2. 4 3-Aix Adjustment
2.2 Installation of Bullet Camera
Note:
Both wall mounting and ceiling mounting are suitable
for the bullet camera. Ceiling mounting will be taken as
an example in this section. And you can take steps of
ceiling mounting as a reference when wall mounting is
adopted.
Steps:
1. Stick the drill template on the ceiling.
2. Drill the screw holes and the cable hole (optional) in
the ceiling according to the supplied drill template.
Note:
Cable hole is required when adopting ceiling outlet to
route the cable.
To Next Page
Loading...
Need help?
General
