Hisense 75H6570G User Manual

Issues Possible solutions
No sound or picture
•Check if the power cord is plugged into a powered AC outlet.
•Press the Power button on the remote control to activate the unit
from ‘Standby’ mode.
•Check to see if the LED light is on or not. If it is, then the TV is
receiving power.
I have connected an external source to
my TV and I get no picture and/or
sound.
•Check for the correct output connection on the external
source and for the correct input connection on the TV.
•Make sure you have made the correct selection for the input mode
for the incoming signal.
When I turn on my TV. there is a delay
for a few seconds before the picture
appears. Is this normal?
•Yes, this is normal. The TV is initializing and searching for
previous setting information.
The picture is normal but there is no
sound
•Check the volume settings.
•Check if ‘Mute’ mode is set to On.
Sound but no picture or black and white
picture
•If the picture is black and white, unplug the TV from the AC outlet
and replug it after 60 seconds.
•Check that the Color is set to 50 or higher.
•Try different TV channels.
The sound and/or picture is distorted or
appears wavy
•An electric appliance may be affecting the TV. Turn off any
appliances that are nearby and move it farther away from the TV.
•Insert the power plug of the TV set into another power outlet.
The sound and picture is blurry or cuts
out
•If using an external antenna, check the direction, position and
connection of the antenna.
•Adjust the direction of your antenna or reset or fine tune the
channel.
A horizontal or vertical stripe appears on
the picture and/or the picture is shaking
•Check if there is an appliance or electric tool nearby that is
causing interference.
The plastic cabinet makes a “clicking”
type of sound
•The ‘dick’ sound can occur when the temperature of the television
changes. This change causes the television cabinet to expand or
contract, which makes the sound. This is normal and the TV is OK.
The remote control does not work
•Confirm that TV still has power and is operational.
•Change the batteries in the remote control.
•Check if the batteries are correctly installed.

Hisense 75H6570G Specifications

General

Screen shape	Flat
Response time	- ms
Display diagonal	75 \
Display brightness	- cd/m²
Display technology	LED
Native aspect ratio	16:9
Supported video modes	2160p
Contrast ratio (typical)	-
Motion interpolation technology	Motion Rate 120
Operating system installed	Android
Audio decoders	DTS
RMS rated power	10 W
Number of speakers	2
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Product color	Black, Grey
Rollable display	No
Panel mounting interface	400 x 300 mm
High Dynamic Range (HDR) technology	Dolby Vision, High Dynamic Range 10 (HDR10)
HDMI ports quantity	3
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports	1
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
AC input voltage	120 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	250 W
Package depth	355.6 mm
Package height	1016 mm
Package weight	25855 g

Weight and Dimensions

Depth (without stand)	76.2 mm
Width (without stand)	1676.4 mm
Height (without stand)	965.2 mm
Weight (without stand)	25401 g