5.7 Pair up with the Subwoofer
6.
Basic Operation
6.1 Standby/On
socket, the main unit will be in STANDBY mode.
• Press the
button on the unit or on the
remote control to switch the unit ON.
• Press the
button again to switch the unit
back to STANDBY mode.
• Disconnect the mains plug from the mains
socket if you want to switch the unit OFF
completely.
6.2 Auto-Standby / Auto-Wake Feature
• [Auto-Standby] During Auto Standby On
15 minutes. For example, this would happen
when pausing playback, or should the
soundbar be left on accidentally.
• [Auto-Wake] If a TV or an external device is
connected (HDMI IN/HDMI ARC/HDMI eARC/
), the unit will switch on
wautomatically hen the TV or the external device
device is switched on.
To disable this feature, please follow the steps
below:
1. During ON mode, pointing the remote a
t the
soundbar, press and hold the
button for 3
seconds to open the menu.
- The unit’s display will scroll “MENU
”.
2. Press the
button 6 times in succession：
the display shows: Auto Wake [ON / OFF].
or
Press the
button 7 times in succession,
the display shows: Auto Standby [ON / OFF].
mode, the soundbar would standby
automatically when no audio is detected for
OPTICAL/AUX mode
Automatic pairing
The subwoofer soundbar will automatically pair
when they are plugged into the mains sockets
and turned on.
No cable is needed for connecting the two units.
• The status of the indicator on the wireless
subwoofer.
LED State Status
Fast blink
Subwoofer in pairing mode
Constant on
Connected / Pairing successfully
Slow blink
Connection / Pairing failed
NOTE:
- Do not press the PAIR button on the rear of
the subwoofer , except for manual pairing.
- If the automatic pairing fails, pair the subwoofer
with the main unit manually.
Manual pairing
1. Ensure that all cables are well connected
and the main unit is in Standby mode.
4. Press and hold the PAIR button on the rear
of the subwoofer for 2 seconds. The subwoofer
will enter the pairing mode and the indicator
on the subwoofer will blink quickly.
2. Press the
button on the main unit or on
the remote control to switch the main unit on.
3. Press the button on the main unit or on the
remote control for 3 seconds to enter Pairing mode.
The display will scroll "SW Pairing".
5. After the wireless connection succeeded, the
Pair indicator will light up and the display on
main unit will scroll "SW IN".
6. If the Pair indicator blink slowly, the
wireless connection has failed. Unplug
the cable of the subwoofer reconnect
the main cables after 3 minutes. Repeat
step 1 ~ 4.
NOTE:
• If the wireless connection fails again, check
if there is conict or strong interference
(for example, interference from an electronic
device) around your location. Remove these
conicts or strong interferences and repeat
the above procedures.
• The subwoofer should be within 6m (18 feet)
of the soundbar in an open area.
• If the main unit is in On mode, and not
connected with the subwoofer, the indicator
on the subwoofer will ash slowly. Follow
step 1~4 above to pair the subwoofer to the
main unit.
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
