- 7 -
(11) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
1.2 Notes
Notes on Safe Handling of the LCD panel and during service
The work procedures shown with the Note indication are important for ensuring the safety of
the product and the servicing work. Be sure to follow these instructions.
• Before starting the work, secure a sufficient working space.
• At all times other than when adjusting and checking the product, be sure to turn OFF the
POWER Button and disconnect the power cable from the power source of the TV during
servicing.
• To prevent electric shock and breakage of PC board, start the servicing work at least 30
seconds after the main power has been turned off. Especially when installing and removing the
power board, start servicing at least 2 minutes after the main power has been turned off.
• While the main power is on, do not touch any parts or circuits other than the ones specified. If
any connection other than the one specified is made between the measuring equipment and the
high voltage power supply block, it can result in electric shock or activation of the
leakage-detection circuit breaker.
• When installing the LCD module in, and removing it from the packing carton, be sure to have
at least two persons perform the work.
To Next Page
Loading...
Need help?
General
