- 17 -
Inserting Batteries in the
Remote Control Handset
Remove the battery cover located on the back
of the handset by gently pulling backwards
from the indicated part.
Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right
directions and replace the battery cover.
Handling the Remote Control
Improper use could cause corrosion or
battery leakage and may result in physical
injury and/or property damage including fire.
Never mix used and new batteries in the
device.
Replace all the batteries in a device at the
same time.
Remove the batteries if the remote control is
not going to be used for an extended period
of time.
To avoid possible failure, read the following
instructions and handle the remote control
properly.
Do not drop or cause impact to the remote
control.
Do not spill water or any liquid on the remote
control.
Do not place the remote control on a wet
object.
Do not place the remote control under the
direct sunlight or near sources of excessive
heat.
Note: Remove the batteries from the remote
control when it is not going to be used
for a long time. Otherwise the batteries
may leak and damage the controller.
Operating Range for the
Remote Control
Point the top of the remote control toward
the LCD TV's remote sensor LED while
pressing a button.
To Next Page
Loading...
Need help?
General