10
English
APPLICATIONS
Wood and aluminum sash.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
Fig. 4
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-3/8" (35mm) plus the thickness of the work bench.
For example, use 2-11/32" (60mm) or larger bolts for a 1" (25mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
Holder (B) adjustment:
Loosen the 6mm bolt with the supplied 10mm box wrench.
Adjust the holder (B) until its bottom surface contacts the work
bench surface.
After adjustment, firmly tighten the 6mm bolt.
CAUTION: Attach the power tool to a work bench with bolts
(6mm), and if the turntable has been swiveled 45°
degrees or more, be careful not to let the hand
that is holding the side handle get caught between
the side handle and heads of bolts (6mm). Injuries
could result.
Fig. 5
11/32" (9mm)
4 Holes
16-11/16" (424mm)
1" (25mm) Thick Bench
Work Bench
5/16" (8mm) Nut
5/16" (8mm) Bolt
Base
10-3/8" (267mm)
6mm Bolt
Move
Adjust the holder
until its bottom
surface contacts the
work bench surface.
Holder (B)
01e_c10fch_e.p65 2/7/04, 16:0210
To Next Page
Loading...
Need help?
General
