English
11
APPLICATIONS
䡬
Cutting various lumber and pocket cutting
䡬
Cutting mild steel plate, aluminum plate, and
copper plate
䡬
Cutting plastics, such as phenol resin and vinyl
chloride
䡬
Cutting thin and soft construction materials
䡬
Cutting stainless steel plate (With No. 97 blade)
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
Fig. 3
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
䡬
The power source voltage is stated on the
nameplate.
䡬
The cord is not damaged.
ASSEMBLY AND OPERATION
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 4 .
Rechargeable
battery
Charger
Pilot lamp
Fig. 4
Latch
Battery
Pull out
Insert
Push
Line
<BSL1430>
<BSL1830>
Line
01Eng_CJ14DSL_US 08/11/7, 09:3211
To Next Page
Loading...
Need help?
General
