Hitachi Compute Rack 220H User Manual

Replacing parts 4-5
Hitachi Compute Rack 220H CRU Replacement Guide
Replacing a power supply
This section describes the power supply replacement procedure.
Location of installing power supply
Install a power supply to the power supply slots. The location of the power supply
slots are as follows.
Figure 4-4: Location of power supply slot
When replacing a power supply in a hot-swap condition, confirm that
another power supply is installed and in active status.
Removing a power supply
1. Confirm the failed power supply.
The Power supply LED lights solid amber.
2. Open the cable clamp to release the AC cable.
3. Disconnect the AC cable from the failed power supply.
NOTICE
Do not disconnect the AC cable
connected to the power supply
which is operating normally.
If you do, the power to the system will be turned off and the
data may be lost.
Power supply slot 1 Power supply slot 2

Hitachi Compute Rack 220H Specifications

General

Brand	Hitachi
Model	Compute Rack 220H
Category	Server
Language	English