Hitachi CP-EX250 User Manual

10
Setting up
Connecting with your devices
Before connecting the projector to a device, consult the manual of the device to
conrm that the device is suitable for connecting with this projector and prepare
the required accessories, such as a cable in accord with the signal of the device.
Consult your dealer when the required accessory did not come with the product or
the accessory is damaged.
After making sure that the projector and the devices are turned off, perform
the connection, according to the following instructions. Refer to the gures in
subsequent pages.
►Use only the appropriate accessories. Otherwise it could
cause a re or damage the projector and devices.
• Use only the accessories specied or recommended by the projector’s
manufacturer. It may be regulated under some standard.
• Neither disassemble nor modify the projector and the accessories.
• Do not use the damaged accessory. Be careful not to damage the accessories.
Route a cable so that it is neither stepped on nor pinched out.
WARNING
►For a cable with a core at only one end, connect the end
with the core to the projector. That may be required by EMI regulations.
CAUTION
• Do not turn on or off the projector while connected to a device in
operation, unless that is directed in the manual of the device. Otherwise it may
cause malfunction in the device or projector.
• The function of some input ports can be selected according to your usage
requirements. Check the reference page indicated beside each port in the
following illustration.
• Be careful not to mistakenly connect a connector to a wrong port. Otherwise it
may cause malfunction in the device or projector.
- When connecting a connector to a port, make sure that the shape of the
connector ts the port.
- Tighten the screws to connect a connector equipped with screws to a port.
- Use the cables with straight plugs, not L-shaped ones, as the input ports of
the projector are recessed.
NOTE
(continued on next page)

Hitachi CP-EX250 Specifications

General

Native aspect ratio	4:3
Projection distance	0.9 - 9.1 m
Projection technology	LCD
Contrast ratio (typical)	2000:1
Screen size compatibility	30 - 300 \
Projector native resolution	XGA (1024x768)
Focal length range	- mm
Lamp type	UHP
Lamp power	215 W
Light source type	Lamp
Service life of light source	- h
Full HD	No
RMS rated power	1 W
USB 2.0 ports quantity	3
S-Video inputs quantity	1
VGA (D-Sub) ports quantity	5
Noise level	- dB
Product type	Portable projector
Product color	White
Market positioning	Portable
Power source	AC
Power consumption (standby)	- W
Power consumption (typical)	320 W
Operating temperature (T-T)	5 - 35 °C
Sustainability certificates	RoHS

Weight and Dimensions

Weight	2900 g