7 EN
How to attach the stand
How to remove the stand
When you transport this product, remove the stand and pack at against the back of the unit in the carton. To remove the stand,
perform the above steps in reverse order.
For wall mounting, the base must be removed. To disconnect the base/stand remove the LE39S406/LE39H316 (x4 screws) and
LE32S406/LE32H316 (x3 screws) screws from the back.
NOTE:
• Unplug the AC cord.
• Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any damage to the unit.
• Do not touch or press the LCD screen, the glass might break under pressure.
Place the TV on its front onto a table.
Align the stand’s bottom-plate (supplied) as seen here.
It will t in only one direction.
Hold the unit and attach as shown in Figure 1.
Finally, secure the bottom-plate with 4 screws (supplied) (4x16mm (5/32x5/8 inches)) as indicated by the arrows in Figure 2.
Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not support your unit correctly, and
could result in damage or injury from tip-over.
•
Screws
LCD PANEL FRONT
Figure 1
Figure 2
NOTE:
Before wall-mounting, please check carefully the location of the TV’s mounting-holes.•
Screws
LE39S406/LE39H316
LE32S406/LE32H316
LE39S406/LE39H316 LE32S406/LE32H316
LE39S406/LE39H316
J3PC1421A_EN.indd 7 8/30/12 9:28:24 AM
To Next Page
General
