1-63
The armrest is a movable type. Keep the armrest in the up
-
right position unless required.
A swelling on the backrest surface can be adjusted by turn
-
ing knob (10) until the desired swelling is obtained.
NOTE: • Turn the knob to adjust the swelling on the lumber
support. The lumbar support adjusting knob works
irrespective of the turning direction.
• When the knob is continuously rotated, swell / shrink
of the backrest is repeated.
Turn the heater ON or OFF by operating switch (11) provid
-
ed on the side of the backrest.
Adjust the headrest position by pulling up or pushing down
the headrest. The headrest height adjusting stroke is 100
mm. In addition, the fore-aft angle of the headrest can be
adjusted in the range of 30° in both sides by pulling forward
or pushing backward the headrest. When required to re
-
move the headrest, fully pull up the headrest.
M4GB-01-097
M4GB-01-099
M4GB-01-098
To Next Page
Loading...
Need help?
General
