Electrical Installations
• Should the consumer battery be removed, isolate the plus
pole (to prevent short circuits when turning on the motor).
• If you are stopping in one place for a very long time, un-
clamp the battery or recharge it regularly.
Battery charger
• Install the battery charger in a dry and well-aired room.
• This device may only be mounted by a professional.
• In case of misuse, the guarantee and the manufacturer's
liability will no longer apply.
• Do not carry out any maintenance work as along as the 230V
mains is still connected.
• Never plug up the ventilation on the lid; ensure that there is
sufcient ventilation.
• Turn off the switch before disconnecting the battery charger
from the 230V mains.
Tank probes
• To avoid incrustations, especially in the sewage tank, never
let the water in the tanks stand for too long.
230V main switch
• Before removing the lid, check that the plug for the electric
mains has been unplugged.
Advice and instructions
Important!
• Any changes to the electrical installation may only be carried
out by a professional electrician.
• Disconnect the battery and switch off the 230V mains before
carrying out any maintenance work.
Batteries
• Please observe the battery manufacturer's operating in-
structions.
• The acid in the battery is poisonous and corrosive. Avoid
contact with eyes and skin.
• If the battery is completely empty, it must be recharged for
a minimum of 10 hours. If the battery has been empty for at
least 8 weeks, it may be damaged.
• Check the amount of liquid in the batteries (acid batteries)
regularly; gel batteries require no maintenance, but must
continuously be recharged.
• Check the level of the battery uid regularly (lead storage
battery).
• Check that the clamps are still on properly and remove any
layers of oxide.
• Unclamp the minus pole if the battery is not being used for
a longer period of time (more than 1-2 months).
06-2
To Next Page
Loading...
Need help?
General
