Vehicle care 179
12. Allow both engines to idle for
approximately 3 minutes with the
leads connected.
13. Switch on the headlamps and the
heated rear window of the vehicle
that received the jump start.
14. Leave the engines running while
removing the BLACK negative
jumper lead rst, followed by the
RED positive jumper lead.
Note
While removing each clamp, do not
touch any other metal while the other
end remains attached.
Towing
Towing the vehicle
Flat-bed tow truck
A at-bed tow truck is the best
method of towing the vehicle to
avoid damage.
When loading onto a at-bed tow
truck, only use the rear towing eye to
pull the vehicle. See Towing another
vehicle on page 180.
Caution
To prevent damage, do not use
the front lashing points for towing
the vehicle.
Standard tow truck
If a at-bed tow truck is not available:
1. Use a standard tow truck, where
the front wheels are raised and
the rear wheels are in contact
with the ground.
MY15_BARINA SPARK_BOOK.indb 179 14/07/2014 12:00:55 PM
To Next Page
Loading...
Need help?
General
