3
4. Press” “ button to set timer(1-12hours). Pressing the button one time increases
one hour for timer. After setting time, the display will show current setting time for 5
seconds, then resume to previous display, meanwhile the light of ” “ will on.
Below photo is an example of setting 8h:
5. Appointment “ON”: In standby mode, press timer button, you can set the
appointment turn-on time in 1-12 hours. After complete setting, the display shows
the appointment turn-on time and also the light ” “ is on. The display
automatically decreases 1 hour for each hour passed. When the appointment
power-on time arrived, the product will automatically turns on. The default setting
temperature is 23 ℃ during appointment turn-on. Below photos is an example to
set appointment turn-on time to 8 hours:
Note: If not setting the temperature and weekly program, the product will
automatically turn-off after 12 hours of continuous work, and enter into standby.
Function operation (ONLY by remote control)
1. Set current TIME/DAY (can set both under standby mode & working status):Press ”
”button for one time, the display shows ”12“ as default,press“ / “ to set
current hour; press “ “ again, the display shows minute “ 30“, press” / “ to
set current minute ,then press “ “ for third time, the display shows the day“ ”,
press “ / “ to set current day(Monday-Sunday: d1-d7) . Then press” “ to
confirm the setting, the display will show previous settings.
For example: Setting to Wednesday, 9:30 AM under 25℃ under II heating, pls. refer
to the following photos:
EN
To Next Page
Loading...
Need help?
General
