4
Note: - The above setting was continue to memorized after power off . then press” “ to
check the current time & day in turn;
-The timer is in 24 hours.
-00~59 minutes.
Note:
When setting temperature, it will use SMART working way:
1)Setting temperature – ambient temperature>2, working with high power-2000W;
2)0<Setting temperature – ambient temperature=<2, working with low power-
1000W;
3)Setting temperature – ambient temperature=0, the cool fan will work for
30seconds to below out the heating left inside, then enter into standby mode.
4)after enter into standby mode, if the machine cool down and:
Setting temperature – ambient temperature>=2, the machine will wake up and
resume to heating.
2.Set temperature
During working status, Press“ / “,the display shows ” 23 “ as default. Press
” / “ to set desired temperature (temperature range 10-49), press” “ to
confirm the setting.
For exampleThe current ambient temperature is 15, when set temperature to
25,the display shows as below:
If you want to cancel the setting temperature, press " " key to choose the heating
I or II, the product will work without setting temperature. While the display " " will
go off, and will show “--”. After continuous heating for 12hours, the cool fan will work
for 30seconds and enter into standby mode.
Set weekly program(ONLY by remote control)
After complete setting of current TIME/DAY, below is the steps to set weekly program:
1)Press ” “, the product enter into working status.
2)Press“ “,the display shows ”P“, it enter into weekly program setting:
EN
To Next Page
Loading...
Need help?
General
