375
uuChecking and Maintaining TiresuWear Indicators
Wear Indicators
The groove where the wear indicator is
located is 1/16 inch (1.6 mm) shallower than
elsewhere on the tire. If the tread has worn so
that the indicator is exposed, replace the tire.
Worn out tires have poor traction on wet
roads.
Tire Service Life
The life of your tires is dependent on many factors, including driving habits, road
conditions, vehicle loading, inflation pressure, maintenance history, speed, and
environmental conditions (even when the tires are not in use).
In addition to regular inspections and inflation pressure maintenance, it is
recommended that you have annual inspections performed once the tires reach five
years old. All tires, including the spare, should be removed from service after 10
years from the date of manufacture, regardless of their condition or state of wear.
1Checking Tires
High speed driving
We recommend that you do not drive faster than the
posted speed limits and conditions allow. If you drive
at sustained high speeds (over 99 mph or 160
km/h), adjust the cold tire pressures as shown below
to avoid excessive heat build up and sudden tire
failure.
Tire Size P235/65R17 103T
Pressure Front: 33 psi (230 kPa, 2.3 kgf/cm
2
)
Rear: 35 psi (240 kPa, 2.4 kgf/cm
2
)
Tire Size P235/60R18 102T
Pressure Front: 35 psi (240 kPa, 2.4 kgf/cm
2
)
Rear: 36 psi (250 kPa, 2.5 kgf/cm
2
)
Example of a Wear
Indicator mark
12 US ODYSSEY Revision-31TK86102.book 375 ページ ２０１５年１０月８日 木曜日 午前１１時４７分
To Next Page
Loading...
Need help?
General
