−
−
Thetapeplayerpicksupdirtand
oxides from the tape. This
contamination builds up over time
and causes the sound quality to
degrade. To prevent this, you should
clean the player aft er every 30 hours
of use.
If you do not clean the tape player
regularly, it may eventually become
impossible to remove the
contamination with a normal
cleaning kit.
Use 100-minute or shorter tapes.
Tapes longer than that may break or
jam in the drive.
If the tape is loose, tighten it by
turning the hub with a pencil or your
finger. If the label is peeling off,
remove it or it could cause the tape
to jam in the player. Never try to
insert a warped or damaged t ape in
the player.
Store tapes in their cases to protect
them from dust and moisture. Never
placetapeswheretheywillbe
exposed to direct sunlight, high heat,
or high humidity. If a tape is exposed
to extreme heat or cold, let it reach a
moderate temperature before
inserting it into the player.
Never try to insert a foreign object
into the tape player.
Press the side of the
SEEK/SK IP bar to find the
beginning of the current song or
passage. Press the side to find
the beginning of the next song or
passage. When the system reaches
the beginning of a song or passage, it
begins to play it.
Press the R PT button
to continuously play a song or
passage. You will see RPT displayed.
The track will repeat until you press
the R PT button again.
The skip and repeat
functions use silent periods on the
tape to f ind the end of a song or
passage. These features may not
work if there is almost no gap
between selections, a high noise
level, or a silent period in the middle
of a selection.
Caring for the Tape PlayerSKIP
REPEAT
Audio System (on vehicles without navigation system)
Features
235
NOTE:
06/08/05 22:14:32 32SMG610_238
To Next Page
Loading...
Need help?
General
