The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM/FM
button. Adjust the volume by turning
the power/volume knob.
PushingtheAUDIObuttononthe
control panel will also t urn on the
system.
You can operate the audio system
with the control buttons on the audio
panel without displaying the audio
control display on the navigation
screen. The audio setting will be
shown in the side display. When the
navigation system is activated, you
will also see the audio setting on the
side display.
The band and frequency that the
radio was last tuned to are displayed.
On the audio control display of the
navigation system and the side
display, the broadcasting station
name may also be displayed if the
RDSisturnedon(seepage ).
To change bands, press the AM/FM
button, or push up the selector on
the interface dial. Each time you
press the button or push up the
selector, the band will change to
FM1, FM2, AM (MW) and LW. On
the FM band, STEREO will be
displayed if the station is
broadcasting in stereo (you will see
STonthesidedisplay).
Stereo reproduction on AM is not
available. On the AM band, AM
noise reduction turns on
automatically.
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
On the audio display of the
navigation screen, you can scroll the
display and enter the setting with the
interface dial. You will see the
indicator , , , or
on the lower display. This
indicates the direction to move the
selector on the interface dial. For the
information of how to use the
interface dial, see page .186
241
CONTINUED
To Play the Radio
To Select a Station
Audio System (on vehicles with navigation system)
Features
237
06/08/05 22:14:49 32SMG610_240
To Next Page
Loading...
Need help?
General
