Before starting, make sure the gear
position indicator in the upper
display shows you that the
transmission is shifted properly.
If the gear position indicator blinks,
the transmission cannot be shifted.
Return the shif t lever to neutral,
pause, then move it again while
pressing the brake pedal.
T he shift lever has three posit ions:
neutral, reverse and driving positions.
It must be in neutral and the brake
pedal must be pressed to start the
engine. You must also press on the
brake pedal when you move the shift
lever out from neutral to the driving
position or reverse.
When you turn the ignition switch to
the ON (II) position, the segment
display of the gear position indicator
comeson,thenitshowsthe
appropriate shift lever position (A, N
or R). If the battery is not well
charged or goes dead, you must
move t he shift lever t o neutral and
press on the brake pedal for about 3
seconds to show the shift lever
position after reconnecting the
battery or jump starting.
CONTINUED
Driving
i-SHIFT (Automated Manual Transmission)
Shifting
327
Upshift
Downshift
DRIVING POSITION
SEGMENT DISPLAY
06/08/05 22:26:44 32SMG610_330
To Next Page
Loading...
Need help?
General
