Honda CRF250L 2019 User Manual

Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the
(Off) position.
1. Remove the left side cover. 2 P. 54
2. Remove the bolts.
3. Remove the battery holder.
4. Disconnect the negative - terminal from
the battery.
5. Disconnect the positive + terminal from
the battery.
6.
Remove the battery taking care not to
drop the terminal nuts.
#
Installation
Install the parts in the reverse order of
removal. Always connect the positive +
terminal first. Make sure that bolts and nuts
are tight.
Make sure the clock information is correct
after the battery is reconnected. 2 P. 22
For proper handling of the battery, see
“Maintenance Fundamentals.” 2 P. 42
“Battery Goes Dead.” 2 P. 87
20161122161659_32KZZE200_eng_BOOK Page 55 Tuesday, November 22 2016 16:19:28 JST
Maintenance
52
Negative terminal
Positive terminal
BoltsBattery Battery holder

Honda CRF250L 2019 Specifications

General

Displacement	249.6cc
Bore x Stroke	76.0mm x 55.0mm
Compression Ratio	10.7:1
Transmission	6-speed
Final Drive	Chain
Front Suspension	43mm inverted fork
Rear Suspension	Pro-Link single shock
Front Brake	Single 256mm disc
Rear Brake	Single 220mm disc
Front Tire	3.00-21
Rear Tire	120/80-18
Wheelbase	56.9 inches
Fuel Capacity	2.1 gallons
Starter	Electric
Fuel System	PGM-FI
Trail	113mm
Engine Type	Liquid-cooled, single-cylinder, four-stroke