9. Blade belt replacement
1. Lower the cutter deck, remove the six yellow colored lock pins (see
p.38) and remove the cutter deck.
2. Remove the bolts and nuts and remove the pulley covers.
3. Pull the belt section between pulley A and pulley B toward you, then
remove the belt from pulley A while releasing it slowly.
CAUTION: If the belt is not released slowly, the idle pulley will move sud-
denly and could injure your hand.
4, Remove the belt from the other pulleys, and replace. the belt.
PULLiY B
I -7 --‘I’
NOTE: When installing the belt
covers, the edge of the left cover
overlaps the right cover under the belt
guide, as shown.
5
LEFi BELT
52
COVER
To Next Page
Loading...
Need help?
General
