Clogged cutter deck discharge chute.
1. Wrong blade.
b.Use genuine Honda blade or equiv-
alent.
2. Deck too low:
) Raise deck and adjust deck height
r--
properly.
3. Engine overloaded.-
Operate at full throttle. Use lower
speed range. Set cutter deck higher
than desired height for first pass,
then cut to desired height on second
pass.
4. Grass bags full
* Empty grass bags.
(Optional part).
Blades do not rotate or stop.
1. Blade drive belt worn or
- Replace with-new belt (see p. 51).
broken.
2. P.T.O. lever cable cut or -
See your authorized HONDA lawn
out of adjustment.
tractor dealer.
3. Faulty P.T.O. clutch assy-
See your authorized HONDA lawn
or worn disk.
tractor dealer.
Tractor does not move, or clutch does not engage properly when the
transmission is shifted into gear.
1. Faulty clutch assy.-
See your authorized HONDA lawn
tractor dealer.
2. Transmission does not -
See your authorized HONDA lawn
.shift gear. .
tractor dealer.
3. Abnormal clutch engage- -
See your authorized HONDA lawn
ment.
tractor dealer.
59
To Next Page
Loading...
Need help?
General
