Honda MB5 1982 User Manual

-
Axle nut torque:
55-65 N.m {5.5 -6. 5 kg-m, 40-47
ft-lb).
• Install the cotter pin. Spread the
cotter pin ends.
• Check the brake adjustment.
• Apply the brake several times and
check for free wheel rotation when
released.
IM · @M@
• If a torque wrench lMJS not used for
installation, see your d«Zier as soon as
possible to verify proper auembly.
CAUTION:
• Always replllce used cotter pins with
new ones.
REAR WHEEL REMOVAL
1. Raise the rear wheel off the ground by
placing a
support block under the
engine.
2. Remove the rear brake adjusting nut
(l) and disconnect the brake rod {2)
from the brake arm (3) by pushing
down on the rear brake pedal. Discon-
nect the stopper arm ( 4) from the
brake panel (5) by removing the cotter
pin, stopper arm nut (6), washer and
rubber grommet.
rw-~-
....
(1) Adjusting nut
(2) Brake rod
(3) Brake arm
(4) Stopper arm
(5) Brake panel
(6) Stopper arm
nut 35

Honda MB5 1982 Specifications

General

Brand	Honda
Model	MB5 1982
Category	Motorcycle
Language	English