#
ID number input
You can input your ID number by pressing the
ignition switch when the ignition switch is
(Off), (Lock) and SEAT FUEL position.
Input the ID number on the ID tag in order
from the left in turn by pressing the ignition
switch.
The ID number is authenticated according to
the number of times the ignition switch is
pushed.
Push the ignition switch the desired number
of times within 5 seconds when the ignition
switch ring comes on. After 5 seconds, the
ignition switch ring goes off and comes on
again. This means that the inputted number
is fixed, and you can input the next number.
u
If the ignition switch ring does not come
on in blue, the battery may be low.
Contact your dealer.
Example:
● To input “0”, wait for 5 seconds without
pushing the ignition switch when the
ignition switch ring comes on.
● To input “1”, push the ignition switch once
within 5 seconds when the ignition switch
ring comes on.
20201006171709_32K1BF000_eng_BOOK Page 126 Tuesday, October 06 2020 17:20:39 JST
Unlock the Ignition Switch in an Emergency
Troubleshooting
123
Continued
To input “0”
To input “1”
ID number
Ignition switch
No push
Ignition switch
ID number
Push one time
To Next Page
Loading...
Need help?
General