CONTROLS
&
EQUIPMENT
EQUIPMENT
Honda UMK422 and UMK431 trimmerdbrush
cutters are supplied with a shoulder harness and
safety glasses. Refer to page 14 for a description
of other equipment and protective clothing you will
need.
Shoulder Harness
A
full shoulder harness must be worn by the
operator of these Honda trimmers/brush cutters
when equipped with a blade and debris shield.
If
the trimmer is equipped with a cutting-line head
and shield with cutoff knife, the operator may
wear a single-strap harness.
A
suitable shoulder harness is supplied with each
new Honda UMK422 and UMK431 trimmer/brush
cutter. Replacement shoulder harnesses may be
purchased through any authorized Honda
trimmedbrush cutter servicing dealer.
Before operation, adjust your shoulder harness as
described on page 16.
Quick-Release
Latch
The shoulder harnesses supplied with these
trimmers are equipped with a quick-release latch.
Pull the latch tab upward to detach the trimmer
from the harness.
insert the latch tongue in the slot of the quick-
release latch to reattach the trimmer
to
the
harness.
Safety Glasses
Safety glasses or goggles that comply with
ANSI
standard 287.1 must be worn by the operator of
any Honda trimmer/brush cutter. The safety
glasses supplied with each new Honda UMK422
and UMK431 trimmedbrush comply with the
ANSI
standard.
FULL SHOULDER HARNESS
n
QUICK-RELEASE
LATCH
SINGLE-STRAP SHOULDER HARNESS
QUICK-RELEASE
LATCH
LATCH TAB
QUICK-RELEASE
LATCH
SAFETY GLASSES (ANSI
287.1)
13
To Next Page
Loading...
Need help?
General
