Honeywell DT92E User Manual

22
DT92E ENERGY SAVING ECO FEATURE
The ECO button allows you to change to a lower, energy saving set temperature for
a period of your choice, from 1 to 24 hours. This temperature is pre-set in the DT92E
Installer Mode, but you can adjust this to any temperature you want when ECO mode
has been activated. The default ECO temperature is 18°C.
At the end of the time period, the thermostat will return to its original set
temperature.
Entering ECO Mode and Setting
the Energy Saving Time Period
Press the green ECO button to enter ECO
mode. The word ECO will appear on the
display and the thermostat will allow you to
set the number of hours you want to be at
the new set temperature.
Use the
and buttons to set the hours,
up to a maximum of 24 hours.
Please note – ECO mode is not accessible
in Holiday mode or if Service shutdown
has occurred.
What Happens in ECO Mode?
In ECO mode, the display will show a
countdown of the remaining time (hours
and minutes) in ECO mode, identified by
the hourglass symbol. The display will
alternate every 5 seconds to show the
current room temperature.
When in ECO mode, pressing the
or
buttons will adjust the set temperature for
the remainder of the ECO time period.
5 s
5 s
5 s
1,2,3,4....,24hr

Honeywell DT92E Specifications

General

Display	LCD
Power Supply	2 x AA batteries
Temperature Range	5°C to 35°C
Mounting	Wall-mounted
Switching Current	3 A
Switching Voltage	230 V AC
Backlight	No
Type	Digital Room Thermostat
Compatibility	Heating systems
Dimensions	92 x 92 x 27 mm
Weight	150g
Control Mode	TPI (Time Proportional Integral)