11
Figure 4: Viewing the Event Log.
The log event displays the event type, time, descriptor and number. Also displayed is the
activation (+) and deactivation (–) signaller.
To display the date of the event currently being displayed press the # key. Pressing the # key
again returns the display to the event details.
Option 5 – Test
The Test option allows the Manager Code (User 14) to test the Bell and Strobe outputs on the
system.
Selecting the Test Option
Enter the Manager Code and press the 5 key.
Operation of the Test Option
On selecting the Test option 5 BELLS is displayed. If the bells are to be tested press the #
key. Any output programmed as Bells will activate. To end the test repress the # key.
Pressing the A key will display 6 STROBE. If the strobes are to be tested press the # key. To
end the test repress the # key.
To exit from the Test option press the esc key.
Option 9 – Log
The Log option permits the system manager (User 14) to view the events stored in the system log.
Selecting the Log Option
Enter the Manager Code and press the 9 key.
The Event Log
Once the Log option has been selected the current date is displayed. To view the Event Log
press the A key to advance through the log or the B key to move backwards through the log.
Figure 4 shows the Event Log display.
09:57 STAR KEY+
¸ ENABLE 092
Event time
Event type
Event activation/
deactivation signaler
Event number
Event descriptor
To Next Page
Loading...
Need help?
General
