Honeywell H2W2PER3 User Manual

Configuring Video Analytics
53
Configuring Face Detection Events
Note
This function is only supported by
HEW4PER2/HEW4PER3B/HEW2PER3/H2W2PER3/H2W4PER3/H2W2PC1M.
Go to Setup  Video Analytics Face Detection.
Figure 7-8 Face Detection
To enable face detection:
1. Select the Enable check box.
2. Click Draw Target to set up the face detection area. You can move or resize the area using
your mouse. To move the area, drag one of the sides. To resize the area, drag one of the
corner handles.
3. Next to Alarm Period, click Setup. The Alarm Period window opens.
4. Set the days and times when you want the alarm function to be active, and then click Save.
5. To enable face enhancement, select the Enable Face Enhancement check box.
6. To start recording video when an event is detected, select the Record check box.
7. In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
8. To send an email notification when an event is detected, select the Send Email check box.
Email settings must be configured in Setup
 Network Setup  SMTP (Email). See
Configuring SMTP (Email) Settings on page 37.
9. To take a snapshot when an event is detected, select the Snapshot check box.
10. To enable face exposure, select the Enable Face Exposure check box. Drag the slider to set
the value of face target brightness and the value of face exposure detection interval.

Honeywell H2W2PER3 Specifications

General

Brand	Honeywell
Model	H2W2PER3
Category	Security Camera
Language	English