IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical shock, or injury when using your
appliance, follow the basic precautions:
Read and understand all instructions before using the water dispenser.
EN 4
Never locate the product where it may fall into a bathtub or other water
container.
DO NOT use in bathrooms or outdoors.
If the unit is damaged or malfunctions, do not continue to operate it. Refer
to the troubleshooting section and/or please seek professional advice.
DO NOT let children play with this appliance, packing, or plastic bags.
DO NOT attempt to repair or adjust any electrical or mechanical functions
of the unit, as this may void the warranty.
Remove the power cord from the electrical receptacle by grasping and
pulling on the power cord plug-end only, never pull the cord.
Always unplug the appliance from the power source before cleaning,
servicing, or relocating the unit. Make sure to turn OFF the unit when the
hot and cold water tanks are empty. Always have water inside the tanks
before turning ON any switch. Overlook of this warning may cause
permanent damage to the unit from overheating.
DO NOT run the power cord under carpeting or cover it with rugs or runners.
Keep the cord away from areas where it may be tripped over.
Do not cut or remove the third (ground) prong from the power cord under
any circumstances. Any questions concerning power and/or grounding
should be directed toward a certified electrician. Improper use of the
grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
Make sure the water dispenser is plugged into an exclusive properly
installed MCB (Miniature Circuit Breaker).
DO NOT operate any product with a damaged cord or plug. Using an
extension cord is not recommended with this appliance.
Before operating the product remove it from its packing and check if it is in
good condition.
Your water dispenser uses 230V , 50Hz electrical current.