INSTALLING YOUR WATER DISPENSER FOR THE
FIRST TIME
IMPORTANT STEPS BEFORE USING YOUR WATER DISPENSER
BEFORE CONNECTING THE APPLIANCE TO THE POWER SOURCE, let it
stand upright for approximately 24 hours. This will reduce the possibility of a
malfunction in the cooling system due to mishandling during delivery.
WARNING: Please make sure to turn OFF the unit when the hot and cold water
tanks are empty. Always have water inside the tanks before turning ON any
switch.
The water dispenser is pre-cleaned at the factory but the reservoir, hot and
cold water tanks, and water lines must be flushed with water before use as
follows (please run the process twice if there is an unpleasant taste or smell
after the first time):
1. Make sure the unit is unplugged.
2. Remove the receptacle by turning it to the left or right depending on the
model. Make sure that the hot water funnel (semi-transparent plastic
piece) is firmly placed on the metal tip of the tank.
3. Fill the water tank with tap water until it is full to at least 1 inch above the
hot water funnel. Allow the water to sit in the hot and cold water tanks for
at least 5 minutes.
4. Press each of the faucets (hot and cold) to confirm that water is coming
out of the dispenser.
5. Plug the dispenser into an outlet. Please review the IMPORTANT SAFETY
INSTRUCTIONS and INSTALLATION GUIDE sections first. The unit will
begin to fill the hot and cold water tanks (this will take approximately
5 minutes). Allow the water to settle in the hot and cold water tanks for
at least 5 minutes. Press on each of the faucets (hot and cold) to confirm
that water is running through the unit.
6. Press the hot water switch, wait a couple of minutes and turn on the cold
water switch. Allow the unit to reach minimum hot and cold water
temperatures. This will take approximately 30-45 minutes and the
indicator lights will turn off.
7. Test the temperature of the water by pressing each of the taps.
8. Turn off the hot and cold switches and unplug the unit from the outlet.
9. Turn the drain cap clockwise to open and drain water from tanks. Do not
tilt the unit to drain water. CAUTION: Hot water may come out of the drain.
10. Close the drain cap by turning it clockwise.
11. The unit is ready to be used.
EN 7
To Next Page
Loading...
Need help?
General
