Honeywell IntelliPath Series User Manual

Section 3: Programming the Communicator
33
PROMPTS OPTIONS DESCRIPTION
64
Zn7 Trigger Type
(V+)_
 (V+)
 (V–)
 (EOLR)
Selects the triggering method for this zone input.
Press the [space] key to scroll through choices.
UL/ULC: V+ must be set as inverted and V– as
non-inverted.
65
Invert Zn7 Y/N
(N)_
[Y], [N]
Inverts the alarm and normal states of the zone 7 trigger;
otherwise uses normal input signal.
66
Restore Zn7 Y/N
(Y)_
[Y], [N]
Enables restore reporting for zone 7.
Zone Trigger mode: This question will only be displayed if zone
7 is not used as the conditional (arming) trigger zone.
UL/ULC: Must be set to “Y.”
67
Delay Zn7 (secs)
(00)_
[01-15]
[00] = no delay
Defines the reporting delay in seconds for zone 7.
Zone Trigger mode: This question will only be displayed if zone
7 is not used as the conditional (arming) trigger zone.
UL/ULC: Must be set to “00.”
68
Rpt Zn7 ONLY if
Armed (N)_
[Y], [N]
Reports alarms on zone 7 ONLY if the conditional zone is
triggered (armed).
If [N], always reports alarms on zone 7.
69
Restore Zn8 Y/N
(Y)_
[Y], [N] Enables restore reporting for zone 8.
UL/ULC: Must be set to “Y.”
70
Delay Zn8 (secs)
(00)_
[01-15]
[00] = no delay
Defines the reporting delay in seconds for zone 8.
UL/ULC: Must be set to “00.”
Prompts 71-77 appear only if communication path includes IP.
71
Use DHCP Y/N
(Y)_
[Y], [N]
Dynamically allocates the IP addresses (recommended); then skip
to Prompt 76: "Enable Pwr Save". If [N], uses fixed IP addresses.
72
NIC IP Address:
255.255.255.255_
12 digit:
xxx.xxx.xxx.xxx
Enter the 4-part address for this device. The 4 parts of the
address must be separated by spaces (displayed as periods in
Review mode).
73
Subnet Mask:
255.255.255.255_
12 digit:
xxx.xxx.xxx.xxx
Enter the 32-bit address mask used to indicate the portion (bits) of
the IP address that is being used for the subnet address. The 4
parts of the address must be separated by spaces (displayed as
periods in Review mode).
74
Gateway IP Addr:
255.255.255.255_
12 digit:
xxx.xxx.xxx.xxx
Enter the 4-part address assigned to the Gateway. The 4 parts of
the address must be separated by spaces (displayed as periods
in Review mode).
75
DNS Serv IP
Addr:
255.255.255.255_
12 digit:
xxx.xxx.xxx.xxx
Enter the 4-part IP address assigned to the DNS (Domain Name
System) server. The 4 parts of the address must be separated by
spaces (displayed as periods in Review mode).
76
Enable Pwr Save
(N)_
[Y], [N]
To meet the 24 hour UL battery backup requirement, choose "Y"
to enable this feature. If this causes connectivity problems with
certain routers or switches, then choose "N" and wire the
communicator so it is powered from a UL listed UPS.

Honeywell IntelliPath Series Specifications

General

Brand	Honeywell
Model	IntelliPath Series
Category	Cell Phone
Language	English